air arms S 400 SPORTE \ PRECISION

New

With quickfill regulator can be used in
air arms S 400 SPORTER or PRECISION .

 89.00 USD

More details

79,00 €

- +

  • High precion of regulation

  • Unique technologic solution

  • You buy directly from the manufacturer

  • 2 years warranty

  • Free shipping all over the world

  • Reviews
  • Instruction
  • Video
  • Results
  • Volume discounts

No customer comments for the moment. Login

Write a review

air arms S 400 SPORTE \ PRECISION

air arms S 400 SPORTE \ PRECISION

With quickfill regulator can be used in
air arms S 400 SPORTER or PRECISION .

 89.00 USD

Write a review

It is appropriate before reading the instructions look at the video instructions and then read the instructions for avoiding common mistakes during installation AirAmrs

Installation is very similar to normal AA classic regulator ( with regulator is send brass terminal which is not used in this airgun )

Mount regulator

Drain all air from airtube and Check inside of airtube and o-ring on regulator, all should be clean without any damage. Spray thread inside of airtube and o-ring on regulator with silicone spray. Push regulator inside airtube (brass regulator towards quickfill). Then push airchamber in airtube too. It should be pushed in such depth that you see approximately half of inner thread inside of airtube.  By screwing it back ( with airchamber inside ) you get your regulator in right position. Installation is complete.

Before filling is needed stretch cocking lever rifle, otherwise air will still pass through the barrel. When filling is necessary to fully open the valve diving bottle until in airtube  is  70bar or more, then it is possible fulfill the a normal speed.

Set regulator

The pressure setting is done by  using a flat screwdriver in the upper part of the regulator.  When we setting regulator we rotate with  inside plastic screw with groove. The output pressure is showed by location colored grooves on the inner plastic screw. The total rotation range of the output pressure is in the range from 100 to 150 bar and is approximately 1/2 turn.

Scale is starting on 100 bar (green color) and ends on 150 bar (red color). Scale is only approximate and course times may change slightly due to fatigue disc springs. Fill the airtube to the maximum pressure which is mentioned by manufacturer.

Recommended output pressure to 16 J is in the range of 100 to 120 bar.

Shipment contains

  • Regulator
  • Brass handle for regulator
  • Airchamber
  • Spare o-rings

Recommended settings rifle after installing the regulator. Set a side screw that restricts the flow through channel in the barrel to achieve minimum consumption at 16J.

Remove the side screw, which is interfere in the channel and then try screw it little by little back until it begins to decrease Shooting speed.

Warning

You must keep maximum cleanness in the entire pressure system (airtube and outer o-rings). Do not disassemble the regulator without previous approval, which will be awarded based on e-mail correspondence, where you provide the reason why it would be necessary to disassemble the regulator. In the case of breach this procedure you may damage the regulator function (fully assembled regulator is not simple and it is necessary to follow the correct procedure). For these reasons, the disassembly without previous consent,or failure exact installation procedure can not claim the warranty. Since regulator is not original part from the manufacturer’s, installation is on your own responsibility.

!!! Dont forget turn on NOTE in youtubevideo. This notes are important for the correct installation , so you can avoid frequent mistakes !!!

We did not have this airgun in our workshop so we do not have video installation.

Installation is simple unscrew valve push regulator then airchamber in so you can see half of thread inside of airtube. By screwing valve back in airtube you move regulator in right position

Regulator can be used only qith quickfill and can not be never filled original way, because then you would push regulator on worng side of airtube.



He you can check video installation for AA classic regulator and qucikfill

What to do when your output pressure increasing over time? This is most likely caused by dirt on o-ring on plastic screw.

In this video is shown how remove dirt and replace o-ring . In video is used Gunpower regulator. Procedure is same for others regulator.

Unfortunately we do not have results for this airgun yet. If you have chrono and this regulator we would be more than happy to add your results.

This regulator was used for example in Italy on 7,5 Joule .

Quantity Discount You Save
2 -1 731,00 € Up to -3 462,00 €

Product options note

These data is only information for us, not mandatory values. For example, if your rifle is currently set on 16J, then you can not with regulator expects higher energy than 16J. The regulator can never increase energy!

For more information, please read FAQ section or contact us by e-mail.

Output pressure we set according to requirements the power rifle with the regulator. If you want a specific output pressure so indicate that in notes for orders.

If you do not know any product options, or you are unsure so please state this in the notes for orders.

Product Options
Full name of airgun model
Full name of airgun model    * Required
Full name 
 
 
* Required
Airgun model
Airgun model    * Required
 
US
 
 
UK
 
 
EU
 
 
AUS
 
 
ASIA
 
Caliber
Caliber    * Required
 
.177 /4.5mm
 
 
.20 /5.0mm
 
 
.22/5.5mm
 
 
.25/6.35mm
 
 
.35/ 9mm
 
Actual measured energy or energy given by the manufacturer
Actual measured energy or energy given by the manufacturer    * Required
 
7,5J / 5,5 ft/lbs
 
 
12J / 9 ft/lbs
 
 
16J / 12 ft/lbs
 
 
21J / 15,5 ft/lbs
 
 
27J / 20 ft/lbs
 
 
33J / 24 ft/lbs
 
 
40J / 30 ft/lbs
 
 
45J / 33 ft/lbs
 
 
50J / 37 ft/lbs
 
 
60J / 44 ft/lbs
 
 
Not specified
 
Required energy with regulator
Required energy with regulator    * Required
 
7,5J / 5,5 ft/lbs
 
 
12J / 9 ft/lbs
 
 
16J / 12 ft/lbs
 
 
21J / 15,5 ft/lbs
 
 
27J / 20 ft/lbs
 
 
33J / 24 ft/lbs
 
 
40J / 30 ft/lbs
 
 
45J / 33 ft/lbs
 
 
50J / 37 ft/lbs
 
 
60J / 44 ft/lbs
 
 
Not specified
 
  
  Quantity: