Cometa Quick fill with manometer

CA-QF-006-001

New

Quick Fill for Airgun is a device that replaces the original air tube plug. Quckfill has manometer with 300 bar scale. In filling pin is screwed reduction which can be connected to paintball coupling. Sprare o-ring for filling pin are  in package.

More details

62,00 €

- +

  • High precion of regulation

  • Unique technologic solution

  • You buy directly from the manufacturer

  • 2 years warranty

  • Free shipping all over the world

  • Reviews
  • Video installation
  • Instruction

No customer comments for the moment. Login

Write a review

Cometa Quick fill with manometer

Cometa Quick fill with manometer

Quick Fill for Airgun is a device that replaces the original air tube plug. Quckfill has manometer with 300 bar scale. In filling pin is screwed reduction which can be connected to paintball coupling. Sprare o-ring for filling pin are  in package.

Write a review

Video Installation

It is appropriate before reading the instructions look at the video instructions and then read the instructions for avoiding common mistakes during installation Quick fill

Unscrew airtube

Before removing plug we need drain all air from airtube.

Unscrew plug holder and pull original plug out of airtube.

Spray silicone spray on Altaros quickfill and push it in airtube until o-ring is hidden in airtube.

Screw original plug holder back on airtube.

Put filling hole cover and quickfill and installation is finished.

 

Pin and filling

Filling pin is made with standart thread G1/8. In filling pin is screwed paintball coupling.

The outer O-rings on the pin must be kept lubricated to prevent damage. Replacement O-rings are 6x1,5 nbr 70 ( nbr is hardeness) and come in a bag with quick fill. When connecting pin, make sure that its larger diameter touches quickfill cover. Fill airtube slowly = open bottle filling valve slowly and only a small opening. If pressure leak out from airtube when we relief pressure in airline, remove plug again and check on the back side small-ring, if is slightly crushed between the screw head and the wall plug.

It must not be pressed to much not even to little, o-ring have to be clean and not damaged.

Shipment contains

  • Quick fill
  • Bar manometer
  • Filling hole cover
  • Filling pin
  • Spare o-ring 6×1,5

Since Quick fill is not original part from the manufacturer’s, installation is on your own responsibility.

 

 

Product options note

These data is only information for us, not mandatory values. For example, if your rifle is currently set on 16J, then you can not with regulator expects higher energy than 16J. The regulator can never increase energy!

For more information, please read FAQ section or contact us by e-mail.

Output pressure we set according to requirements the power rifle with the regulator. If you want a specific output pressure so indicate that in notes for orders.

If you do not know any product options, or you are unsure so please state this in the notes for orders.