Cometa Quick fill with manometer

Videos for installation Altaros quick fill in Quickfill Cometa

Cometa quickfill video Installation

Quick fill installation instruction for Cometa

It is appropriate before reading the instructions look at the video instructions and then read the instructions for avoiding common mistakes during installation Quick fill

Unscrew airtube

Before removing plug we need to drain all air from airtube.

Unscrew plug holder and pull original plug out of airtube.

Spray silicone spray on Altaros quickfill and push it in airtube until o-ring is hidden in airtube.

Screw original plug holder back on airtube.

Put filling hole cover and quickfill and installation is finished.

Pin and filling

Filling pin is made with standard thread G1/8. In filling pin is screwed paintball coupling.

The outer O-rings on the pin must be kept lubricated to prevent damage. Replacement O-rings are 6x1,5 nbr 70 ( nbr is hardeness) and come in a bag with quick fill. When connecting pin, make sure that its larger diameter touches quickfill cover. Fill airtube slowly = open bottle filling valve slowly and only a small opening. If pressure leak out from airtube when we relief pressure in airline, remove plug again and check on the backside small-ring, if is slightly crushed between the screw head and the wall plug.

It must not be pressed too much not even to little, o-ring has to be clean and not damaged.

Shipment contains

• Quick fill
• Bar manometer
• Filling hole cover
• Filling pin
• Spare o-ring 6×1,5

Since Quick fill is not original part from the manufacturer’s, installation is on your own responsibility.