BSA ultra airgun regulator
Airgun regulator for BSA Ultra
This Airgun Regulator does not need drilling in the tank. Unscrew the air tube from airgun body. Insert regulator in begin air tube and then screw air tube back to airgun body.
Setting pressure of airgun regulator
Altaros regulator output pressure can be set from 100bar (1450 PSI) to 150bar (2200 PSI). For a quick setting is on regulator engraved scale according to which the desired output pressure can be set. The total scale range of 100-150bar corresponds to approximately 1/2- turn. Unscrewing, or screwing setting screw more than 1 turn may result in a malfunction of the regulation and scale will not show you regulated pressure. Groove on red marked half of setting plastic screw represents pointer which shows you currently set pressure on the scale. To change the pressure on regulator, just simply rotate the set screw with the flat screwdriver in the appropriate direction according to regulator scale.
Regulator pressure scale with three different settings
Warning:
Never unscrew regulator brass screw plugs! If you do so the regulator immediately stops working and repair is only possible at the manufacturer!
You must keep maximum cleanness in the entire pressure system (airtube and outer o-rings).
The disassembly of the internal parts regulator or failure at the exact installation procedure means that you can not claim the warranty. Since the regulator is not original part from the manufacturer’s, installation is on your own responsibility.
Results with our Altaro regulator
JSB heavy 4.5mm 0.67g (0.177)
Average | 198,3ms |
Min | 197,5ms |
Max | 199,3ms |
Difference | 1,8ms |
Shots | 37 |
Power | 13.1J |