Crosman challenger airgun regulator

Reference CA-RE-009-001

The easiest and fastest installation regulator in the world.

This Airgun Regulator does not need drilling in the tank. Installation is very easy. Just screw mounting stick on regulator, unscrew plug on airtube and push regulator on bottom airtube.

After regulator installation will your airgun manometer show regulated pressure.

More on:
Info
video
instruction
results

Caliber: .177 /4.5mm

Required energy with regulator: 7,5J / 5,5 ft/lbs

Kč2,200.00

Quantity

Product Details

Airgun regulator for Crosman Challenger

This Airgun Regulator does not need drilling in the tank. Installation is very easy. Just screw mounting stick on regulator, unscrew plug on airtube and push regulator on bottom airtube. Unscrew mounting stick and screw plug back on airtube. It is similar to Benjamin Marauder ( you can see the installation in Marauder video section ).

Videos for installation and proper use regulator in the airgun Crosman Challenger

Crosman Challenger video Installation is very similar to BSA Bucaneer

Installation instructions for Crosman Challenger air rifle pressure regulator

You can find video installation in the video section, written instructions will be added soon

Setting pressure of airgun regulator

Altaros regulator output pressure can be set from 100bar (1450 PSI) to 150bar (2200 PSI). For a quick setting is on regulator engraved scale according to which the desired output pressure can be set. The total scale range of 100-150bar corresponds to approximately 1/2- turn. Unscrewing, or screwing setting screw more than 1 turn may result in a malfunction of the regulation and scale will not show you regulated pressure. Groove on red marked half of setting plastic screw represents pointer which shows you currently set pressure on the scale. To change the pressure on regulator, just simply rotate the set screw with the flat screwdriver in the appropriate direction according to regulator scale.
Regulator pressure scale with three different settings

Warning:

Never unscrew regulator brass screw plugs! If you do so the regulator immediately stops working and repair is only possible at the manufacturer!

You must keep maximum cleanness in the entire pressure system (airtube and outer o-rings).

The disassembly of the internal parts regulator or failure at the exact installation procedure means that you can not claim the warranty. Since the regulator is not original part from the manufacturer’s, installation is on your own responsibility.