Spa P10 bullpup airgun regulator

P12 bullpup
search
  • P12 bullpup
  • P12 bullpup
  • P12 bullpup
  • P12 bullpup
CA-RE-023-001

This Airgun Regulator is vented to atmosphere, but without drilling in the tank.

  • 250 char. max
Caliber: .177 /4.5mm
Required energy with regulator: 7,5J / 5,5 ft/lbs
€89.00
Quantity

visa

Airgun regulator for Spa P10

This Airgun Regulator is vented to atmosphere, but without drilling in the tank.

Videos for installation and proper use regulator in the airgun Spa P10

Spa P10 video Installation

Setting output pressure on regulator

What to do when your output pressure increasing over time? This is most likely caused by dirt on o-ring on plastic screw.

In this video is shown how remove dirt and replace o-ring. In video is used Gunpower regulator. Procedure is the same for other regulators.

Video how to take regulator out of regulator body

Correct clean air tube and regulator

Installation instruction for Spa P10 air rifle pressure regulator

It is appropriate before reading the instructions look at the video instructions and then read the instructions for avoiding common mistakes during installation

Installation is the same as for all others vented regulators. Empty all presure from airtube, unscrew airtube from valve, remove o-ring from valve, put regulator in airtube and screw valve back on airtube. Do not screw airtube on valve fully, leave small gap between them (0,2 mm +-) by doing this and removing o-ring from valve you created venting hole without need for any drilling in airtube.

Setting pressure of airgun regulator

Altaros regulator output pressure can be set from 100bar (1450 PSI) to 150bar (2200 PSI) and after consultation of up to 170bar (2500PSI) which corresponds to the rotation of the screw behind value 150bar so that the line of the screw is pointing to the letter R. For a quick setting is on regulator engraved scale according to which the desired output pressure can be set. The total scale range of 100-150bar corresponds to approximately 2/3 turn Unscrewing, or screwing setting screw more than 1 turn may result in a malfunction of the regulation and scale will not show you regulated pressure. Groove on red marked half of setting plastic screw represents pointer which shows you currently set pressure on the scale. To change the pressure on regulator, just simply rotate the set screw with the flat screwdriver in the appropriate direction according to regulator scale.


Regulator pressure scale with three different settings


In this picture you will find an old scale (set at 100 bar), which we no longer sell.

Results with installed regulator in air gun Spa P10

P12 bullpup without regulator with JSB heavy 0.67g

P12 bullpup with regulator set on 100bar with JSB heavy 0.67g

P12 bullpup with regulator set on 125 bar with JSB heavy 0.67g

Compared with and without regulator

You might also like