BSA Ultra XL Airgun regulator
The easiest and fastest installation regulator in the world.
This Airgun Regulator does not need drilling in the tank. Unscrew the air tube cap. Insert regulator on bottom of air tube and then screw back in airtube.
- More on:
Airgun regulator for BSA BSA Ultra XL
This Airgun Regulator does not need drilling in the tank. Unscrew the air tube cap. Insert regulator on the bottom of airtube and then screw back in airtube.
Videos for installation and proper use regulator in the airgun BSA Ultra XL
BSA Bucaneer video Installation is same as for BSA Ultra XL
Setting output pressure on regulator
What to do when your output pressure increasing over time? This is most likely caused by dirt on o-ring on plastic screw.
Installation instructions for BSA BSA Ultra XL air rifle pressure regulator
It is appropriate before reading the instructions look at the video instructions and then read the instructions for avoiding common mistakes during installation
BSA Ultra XL
1) Unscrewing the airtube
Before removing plug we need to drain all air from airtube, we can shoot without pellets for drain air. Unscrew coupler between airtube and barrel, then remove the plug itself. For unscrewing plug we can use mounting stick as a lever.
2) Mounting of the regulator
Screw the installation stick to the regulator and check o-ring, if it is clean and not damaged. Spray o-ring with silicone spray for preventing any damage. Push regulator to the bottom of airtube then unscrew mounting stick and screw quickfill plug back .
3) Setting pressure of airgun regulator
Altaros regulator output pressure can be set from 100bar (1450 PSI) to 150bar (2200 PSI). For a quick setting is on regulator engraved scale according to which the desired output pressure can be set. The total scale range of 100-150bar corresponds to approximately 1/2- turn. Unscrewing, or screwing setting screw more than 1 turn may result in a malfunction of the regulation and scale will not show you regulated pressure. Groove on red marked half of setting plastic screw represents pointer which shows you currently set pressure on the scale. To change the pressure on regulator, just simply rotate the set screw with the flat screwdriver in the appropriate direction according to regulator scale.
Regulator pressure scale with three different settings
4) Shipment contains
Never unscrew regulator brass screw plugs! If you do so the regulator immediately stops working and repair is only possible at the manufacturer!
You must keep maximum cleanness in the entire pressure system (airtube and outer o-rings).
The disassembly of the internal parts regulator or failure at the exact installation procedure means that you can not claim the warranty. Since the regulator is not original part from the manufacturer’s, installation is on your own responsibility.
Results with installed regulator in air gun BSA Ultra XL
BSA Ultra XL is very similar to BSA bucaneer SE
BSA bucaneer SE with altaros regulator 4.5mm ( .177 ) JSB exact 0.547g