Benjamin Wildfire airgun regulator
The easiest and fastest installation regulator in the world.
This Airgun Regulator does not need drilling in the tank. Installation is very easy. Just screw mounting stick on regulator, unscrew plug on airtube and push regulator on bottom airtube.
- More on:
- Info
- video
- instruction
- results
Airgun regulator for Benjamin Wildfire
This Airgun Regulator does not need drilling in the tank. Installation is very easy. Just screw mounting stick on regulator, unscrew plug on airtube and push regulator on bottom airtube. Unscrew mounting stick and screw plug back on airtube. It is similar to Benjamin Marauder ( you can see installation in Marauder video section ).
Videos for installation and proper use regulator in the airgun Benjamin Wildfirer
Benjamin Wildfire video Installation is very similar to BSA Bucaneer |
Installation instruction for Benjamin Wildfire air rifle pressure regulator
You can find video installation in video section, written instructions will be added soon
Setting pressure of airgun regulator
Altaros regulator output pressure can be set from 100bar (1450 PSI) to 150bar (2200 PSI). For a quick setting is on regulator engraved scale according to which the desired output pressure can be set. The total scale range of 100-150bar corresponds to approximately 1/2- turn. Unscrewing, or screwing setting screw more than 1 turn may result in a malfunction of the regulation and scale will not show you regulated pressure. Groove on red marked half of setting plastic screw represents pointer which shows you currently set pressure on the scale. To change the pressure on regulator, just simply rotate the set screw with the flat screwdriver in the appropriate direction according to regulator scale.
Regulator pressure scale with three different settings
Warning:
Never unscrew regulator brass screw plugs! If you do so the regulator immediately stops working and repair is only possible at the manufacturer! Regulator must be installed no later than six months after purchase. Ideally immediately upon delivery.
You must keep maximum cleanness in the entire pressure system (airtube and outer o-rings).
The disassembly of the internal parts regulator or failure at the exact installation procedure means that you can not claim the warranty. Since the regulator is not original part from the manufacturer’s, installation is on your own responsibility.
Results with installed regulator in air gun Crosman Challenger
Big thanks for Results from Scott
The pellet is the Crosman Premier Brown Box .177 and weighs 7.97 grain.
Unfortunately we do not have result for Benjamin Wildfire , airgun uses the same airtube like Crosman Challenger.