SPA Artemis PP700 airgun regulator

SPA Artemis PP700 airgun regulator
search
  • SPA Artemis PP700 airgun regulator
  • SPA Artemis PP700 airgun regulator
CA-RE-023-003

The easiest and fastest installation regulator in the world.

This Airgun Regulator does not need drilling in the tank. Installation is very easy. Empty your airtube.

Unscrew quickfill, you can push regulator mounting stick in filling pin hole and use it as lever.

Screw mounting stick on regulatore and push regulator on bottom in middle of valve.

When is regulator on bottom unscrew ounting stick, screw quickfill back and installation is finished.

  • 250 char. max
Caliber: .177 /4.5mm
Required energy with regulator: 7,5J / 5,5 ft/lbs
€89.00
Quantity

Airgun regulator for SPA Artemis PP700

This Airgun Regulator does not need drilling in the tank. Installation is very easy. Empty your airtube.

Unscrew quickfill, you can push regulator mounting stick in filling pinhole and use it as a lever.

Screw mounting stick on the regulator and push regulator on the bottom in middle of valve.

When is regulator on bottom unscrew mounting stick, screw quickfill back and installation is finished.

Videos for installation and proper use regulator in the airgun SPA Artemis PP700

SPA Artemis PP700 video Installation

Installation instruction for Benjamin Discovery air rifle pressure regulator

You can find video installation in the video section.

The original regulator can be turned off if you put Allen key in a hole in the trigger guard area. We slowly screw in around 1 turn (clockwise). By doing this you turn of original regulator and regulation will be done by Altaros regulator only.

Setting pressure of airgun regulator

Altaros regulator output pressure can be set from 100bar (1450 PSI) to 150bar (2200 PSI). For a quick setting is on regulator engraved scale according to which the desired output pressure can be set. The total scale range of 100-150bar corresponds to approximately 1/2- turn. Unscrewing, or screwing setting screw more than 1 turn may result in a malfunction of the regulation and scale will not show you regulated pressure. Groove on red marked half of setting plastic screw represents pointer which shows you currently set pressure on scale. To change the pressure on regulator, just simply rotate the set screw with the flat screwdriver in the appropriate direction according to regulator scale.
Regulator pressure scale with three different settings

Warning: 

Never unscrew regulator brass screw plugs! If you do so the regulator immediately stops working and repair is only possible at the manufacturer!

You must keep maximum cleanness in the entire pressure system (airtube and outer o-rings).

The disassembly of the internal parts regulator or failure at the exact installation procedure means that you can not claim the warranty. Since the regulator is not original part from the manufacturer’s, installation is on your own responsibility.

Results with installed regulator in air gun SPA Artemis PP700

When you shooting check if barrel closure sealing right.

In case that closure does not seal fine there is a chance that there will be random air leak when fired which can lead to difference in consistency.

Results with Spa Artemis 4,5, Pellets 0,547 JSB , comparing original and Altaros regulator


You might also like